Juniper-systems Allegro DOS Manual Manuel d'utilisateur télécharger pdf (Page 30)

Page 2-12 Hardware Features

▲▲

▲

Cleaning the Keyboard

Dirt and debris can get underneath the keyboard bezel. To clean it, use a

coin to pull the bezel up at the recess located at the bottom of the

keyboard and remove it. We recommend that you use warm water, mild

detergent, and a toothbrush to clean the keyboard or simply brush it

out. The Allegro remains sealed during this process. (Do not direct a

high pressure stream of water at the keyboard to clean it. This action

could break the seal, causing water to get inside the Allegro.)

Reattach the bezel by carefully inserting the top ridge under the

function keys and lowering the bezel down flat onto the case. Press

down along the sides while aligning the keys through the holes.

❖ Important Note: After you reattach the bezel, check each key to make sure it

is completely free from the bezel. If any part of a key is caught underneath the

bezel, you may not be able to turn the Allegro on or you may hear a continuous

string of beeps.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 273 274

Pas de commentaire

Juniper-systems Allegro DOS Manual Manuel d'utilisateur Page 30