Juniper-systems Allegro DOS Manual Manuel d'utilisateur télécharger pdf (Page 199)

MS-DOS Page 5-39

The Allegro will start with a basic configuration instead of your usual

configuration. For example, device drivers for PC cards will not be

loaded and environment variables will be set to their default values.

Bypassing Individual Commands

If you suspect your problems are related to a specific command, you can

view each command individually and bypass only the command you

think may be causing the problems. To review individual commands,

follow these steps:

1) Reboot the Allegro by pressing the <ON/OFF> key for 8 to 10 seconds

(just until the screen clears). After the system starts, DOS displays the

following message:

Starting MS-DOS...

2) While the text is on your screen, quickly press and release the <F8>

key. One by one DOS displays each command in your CONFIG.SYS

file followed by a prompt. To accept a command, press <Y> for yes.

To bypass a command, press <N> for No.

3) When DOS finishes processing the CONFIG.SYS file, the following

prompt appears:

Process AUTOEXEC.BAT [Y, N]?

Press <Y> for yes, if you also want to view the commands in your

AUTOEXEC.BAT file.

1 2 ... 194 195 196 197 198 199 200 201 202 203 204 ... 273 274

Pas de commentaire

Juniper-systems Allegro DOS Manual Manuel d'utilisateur Page 199