Juniper-systems Mesa Connector module Manuel d'utilisateur télécharger pdf

6. Remove the four screws on the back

of the Mesa that are holding down the

connector module (circled below). Set

these screws aside for reuse.

7. Remove the connector module. A

connector protector is attached to it.

8. Remove the connector protector from

the current module and place it on the

new connector module (shown from

the bottom view below). Make sure it is

seated properly on the module.

9. Place the new connector module and

connector protector on the Mesa,

making sure the bottom side of the

connector protector is seated properly

inside the groove on the case back.

10. Insert the four screws into the back of the

Mesa where the module is held in place

and screw them in (reverse of step 6).

11. Put the bumpers back into position. Insert

and screw in eight screws (two on each

corner as shown in step 4) to re-attach

the top and bottom bumpers.

12. Test one or more of the connectors to

make sure the new module is working.

13. Reattach the hand strap if desired.

tel: 435.753.1881

web: www.junipersys.com

1132 W. 1700 N. Logan, UT 84321

Contents of Connector Module Kit

The Mesa Rugged Notepad™ connector

module replacement kit includes the

following items:

 Connector module

 Four screws

 Screwdriver

 Instruction sheet

Replacement Instructions

1. Suspend or power off the Mesa.

2. If a hand strap is attached to the Mesa,

remove it.

3. Place the Mesa display side down on a

at surface.

4. Remove the eight screws (two on each

corner as shown) that attach the top

and bottom bumpers to the Mesa.

5. Carefully remove the bumpers to allow

access to the connector module.

Note: If you have a Geo model, use

caution while removing and installing

the top extended antenna bumper to

avoid damaging the antenna assembly.

replacement instructions

connectormodule

mation is subject to change without notice. Juniper Systems

and Mesa Rugged Notepad are trademarks of Juniper Systems,

Inc.

Replacement Instructions 1

Résumé du contenu

Page 1 - Replacement Instructions

6. Remove the four screws on the back of the Mesa that are holding down the connector module (circled below). Set these screws aside for reuse. 7. R

Commentaires sur ces manuels

Pas de commentaire

Juniper-systems Mesa Connector module Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Juniper-systems Mesa Connector module. Juniper Systems Mesa Connector module User Manual [de] [fr] [it] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Juniper-systems Mesa Connector module