Juniper-systems TK6000 I/O Module Manuel d'utilisateur télécharger pdf

TEL: 435.753.1881 FAX: 435.753.1896 WEB: www.junipersys.com

The following items should be included in

the replacement kit:

▪ Instructions

▪ I/OModule

▪ Screwdriver

P/N: 20389-03 12/13

1132W.1700N.Logan,UT84321

Complete the following steps to replace the

I/O module on the TK6000.

Note: There are no replacement screws for the

bumper in the kit.

1. Remove bumper screws and case back screws.

2. Remove the four 4 mm screws that are easily

accessible on the I/O module. There are two at

the bottom of the board and two on either side

set in the bridge of plastic that covers part of

the I/O board.

3. Remove the four 5 mm screws that are set

under the plastic bridge. There are four holes in

the bridge that allow the provided screwdriver

to t through the plastic to reach the screws.

4. Hold the module by the plastic bridge and pull

it off.

5. Take the new module from the kit and place

it in the TK6000. It should settle in without

needing any force.

6. Attach the four 4 mm screws that come with

the kit. Tighten them snugly in place.

CAUTION: It is possible to over-tighten the

screws and strip the screw hole threads. To

avoid this, tighten the screws using the Phillips

end of the included screwdriver. If the threads

are accidentally stripped, contact a service

center to schedule a repair.

Note: The screw heads can be pushed onto the

screwdriver which will hold them in place.

7. Carefully place the four 5 mm screws through

the holes in the bridge and tighten them snugly

in place.

8. Reattach the case back and tighten the four

screws.

9. Replace the top bumper with the two screws on

either side.

10. Test the connections of the newly replaced I/O

module.

BumperScrews

CaseBackScrews

5mmScrews

4mmScrews

▪ 4mmscrews(4)

▪ 5mmscrews(4)

I/O Module

I/O Module 1

Résumé du contenu

Page 1 - I/O Module

TEL: 435.753.1881 FAX: 435.753.1896 WEB: www.junipersys.com The following items should be included in the replacement kit:▪ Instructions▪ I/

Commentaires sur ces manuels

Pas de commentaire

Juniper-systems TK6000 I/O Module Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Équipement Juniper-systems TK6000 I/O Module. Juniper Systems TK6000 I/O Module User Manual [fr] [de] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Juniper-systems TK6000 I/O Module