Juniper-systems Allegro DOS Quick Start Manuel d'utilisateur télécharger pdf

ALLEGRO

DOS

QUICK START GUIDE

Installing the battery pack into the Allegro

Before turning on the Allegro, the battery pack must be installed. To do

this, complete the following steps:

Push up on the release latches on the

sides of the Allegro to open the battery

compartment door.

Place the NiMH battery pack in the left side

of the battery compartment, push down,

and slide it to the right.

Push the battery door closed until each

release latch clicks into place.

Slide the release latches downward until

they cannot slide any further to securely

latch the battery door closed.

Do not turn on the Allegro yet.

Plug the AC wall charger that came with

the Allegro into the wall socket.

Note: A small green light on the wall adapter

turns on when it is plugged into the wall.

Remove the rubber protector from the

Allegro’s external power input jack.

Plug the power connector end of the AC

wall charger into the Allegro. The Allegro

turns on automatically.

The MS-DOS operating system loads onto

the Allegro, a progress bar appears. No

action is required until the New Battery

Detected screen appears.

Before you begin using your Allegro DOS

Complete all of the steps outlined in each section of this guide.

1 2 3 4

Résumé du contenu

Page 1 - DOS

ALLEGRO DOS QUICK START GUIDEInstalling the battery pack into the AllegroInstalling the battery pack into the AllegroBefore tur

Page 2

Setting the Battery Packs Charge LevelSetting the Battery Packs Charge LevelThe battery charge level must be set before you can use your Allegro. To d

Page 3

Install Acrobat ReaderInstall Acrobat ReaderIt is not required to complete this section if you already have Acrobat Reader installed on your desktop P

Page 4 - HarvestMaster

1740 North Research Park WayLogan, UT 84341-1977 USATel +1 435.753.1881Fax +1 435.753.1896Email [email protected] www.junipersys.coma Cam