Juniper-systems Allegro MX User Guide Manuel d'utilisateur télécharger pdf (Page 31)

Installing a Micro SD Card

To install a Micro SD card complete the following steps:

1. Use a screwdriver to open the back compartment door.

2. Gently li the ap located in the top right corner of the

board protector.

3. Slide the Micro SD card door to the right to open it.

4. Slide the Micro SD card into the door with the connectors

facing down and outward.

CAUTION: Do not place the Micro SD card directly into

the board connector. The card reader and the card may be

damaged.

5. Gently shut the door and slide it to the le to lock it.

6. Close the ap in the board protector and securely reaach

the back compartment door.

7. For the card to be recognized, suspend and resume or reset

the Field PC.

Removing a Micro SD Card

To remove a Micro SD card, follow the steps outlined above

starting with step 6 in reverse order.

Ch 4 Using the Hardware 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 95 96

Pas de commentaire

Juniper-systems Allegro MX User Guide Manuel d'utilisateur Page 31