Juniper-systems Allegro 2 User Guide Manuel d'utilisateur télécharger pdf (Page 31)

Ch 2 Hardware Components 27

Flashlight

Geo units have a ash LED located underneath the camera

window on the back of the Allegro 2. It can be used as a

ashlight, although its primary purpose is as a ash for the

camera.

To use the ashlight you can tap the ashlight gadget if it

is on the Home screen or press the orange + F keys. Tap

on the icon or press the keys once to turn on the brightest

illumination, again for medium brightness, and a third time

to turn it off.

SD Cards

The Allegro 2 has a slot for a micro SD card located in the

battery compartment. To insert or remove a card follow

these steps:

1. Power off the handheld.

2. Loosen the screws to the battery compartment, and

remove the door. The hand strap remains attached.

CAUTION: The Allegro 2 is not sealed against water and

dust when the battery door is not installed properly.

3. Remove the battery pack.

4. An image on the battery compartment label shows the

correct location and orientation for the SD card (slot

on the right). Push the card into the slot to insert it. To

remove the SD card, pull it out.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 118 119

Pas de commentaire

Juniper-systems Allegro 2 User Guide Manuel d'utilisateur Page 31